Not extrudingUpdated 7 months ago
This guide addresses the issue when your 3D printer is not extruding filament at the very beginning of a print. Let’s walk through some common solutions to get your printer back to working condition.
Check the Basics
Before diving into more complex troubleshooting, double-check the basics:
- Power Supply: Ensure the printer is powered on and connected properly.
- Filament Spool: Verify that the filament spool is not empty.
- Filament Feed: Confirm that the filament is not tangled or caught on the spool.
- Filament Loading: Make sure the filament is properly loaded into the extruder.
Avoid clogging
A clogged nozzle is a common reason for filament not extruding. You can tell this is happening if the extruder motor is clicking or slipping but the filament is not being pushed out. Clogged nozzles can be caused by too much retraction or debris inside the nozzle. Refer to the [Nozzle Clogging] article for detailed solutions.
Adjust Nozzle Temperature
Incorrect temperature settings can also prevent extrusion. Ensuring the nozzle temperature is correctly set according to the recommended printing conditions for the specific filament is crucial. Please ensure the nozzle temperature is set according to the filament's recommended settings, which can be found on the package or in Technical Data Sheet (TDS).
Stripped Filament by Grinding
Most 3D printers use a small gear to push the filament back and forth. If there are plastic shavings or if the extruder motor is spinning but the filament is not being pulled into the extruder, then the filament might be stripped. Refer to the [Grinding Filament] article for detailed solutions.
Nozzle Too Close to the Bed
If the nozzle is too close to the build table surface, there will not be enough room for plastic to come out of the extruder. This can be identified if the print begins to extrude normally after the first several layers. Therefore, try increase the Z offset in the slicer until there is enough room for the plastic to extrude properly.
If you continue to encounter difficulties, please contact Overture Service for further assistance.